Indirect Oxidation of Organic Substances by Intermediates of the Oxygen Reduction

Results of two urgent and practically important directions of research on the indirect oxidation of organic compounds by highly reactive intermediates generated electrochemically from oxygen (HO₂ ^–, HO₂ ^·, HO^·) are considered and orderly arranged. The studies in question are the indirect synthesis and mineralization of organic toxicants in waste water.     

Polyaniline/12-phosphotungstic acid/V<Subscript>2</Subscript>O<Subscript>5</Subscript> nanocomposite and its platinum analog as oxygen reduction electrocatalysts

A guest-host nanocomposite based on electroconducting polyaniline doped with 12-phosphotungstic acid and V₂O₅ as well as its bifunctional analog containing not more than 5 mass% nanosized platinum were obtained. A study was carried out on the structure of these nanocomposites, their redox characteristics, and electrocatalytic activity in the reduction of oxygen. These nanocomposites were found to display catalytic properties in the electrochemical reduction of oxygen, while the presence of even a slight amount of nanosized platinum in the bifunctional composite leads to a significant increase in its electrocatalytic activity. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 5, pp. 307–314, September–October, 2007.     

电激励O2（1△g）发生器的理论模拟研究

 建立了基于分子反应动力学的氧等离子体化学反应模型，该模型包括了电子与氧分子，以及氧原子与氧分子的碰撞反应过程。利用反应动力学理论计算并讨论了电激励O₂(¹△)发生器的放电参数，发现电子能量应小于2.5eV。电子浓度对O₂(¹△)产率的影响不大，当放电压力与气体线流速一定时，存在最佳的电子平均能量。     

横向射流式单重态氧发生器的性能实验研究

 对氧碘化学激光器的单重态氧发生器（SOG）进行了改进，采用横向射流方式，并对该横向射流式单重态氧发生器的性能进行了检测。实验中过氧化氢碱溶液温度控制在－16℃左右,氯气流量为530mmol/s，He与氯气的流量比为3;采用PS法测量单重态氧分子的产率,吸收法测量氯气的利用率和相对水含量。得出如下结论:在不使用冷阱和分离器的情况下，最高单重态氧分子产率达到58%, 氯气利用率在80%以上,相对水含量小于等于0.5;气体达到最大流量时,发生器仍然能稳定地工作。     

Stress State of Multilayer Thin-Walled Elements with Interfacial Defects of Structure

Based on the discrete-structural theory of thin plates and shells, a calculation model for thin-walled elements consisting of a number of rigid anisotropic layers is put forward. It is assumed that the transverse shear and compression stresses are equal on the interfaces. Elastic slippage is allowed over the interfaces between adjacent layers. The solution to the problem is obtained in a geometrically nonlinear statement with account of the influence of transverse shear and compression strains. The stress-strain state of circular two-layer transversely isotropic plates, both without defects and with a local area of adhesion failure at their center, is investigated numerically and experimentally. It is found that the kinematic and static contact conditions on the interfaces of layered thin-walled structural members greatly affect the magnitude of stresses and strains. With the use of three variants of calculation models, in the cases of perfect and weakened contact conditions between layers, the calculation results for circular plates are compared. It is revealed that the variant suggested in this paper adequately reflects the behavior of layered thin-walled structural elements under large deformations. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 6, pp. 761–772, November–December, 2005.     

Influence of radiation on thin ZnS-Tb films

Changes in thin zinc-sulfide films under the action of the γ-radiation of Co⁶⁰ are studied by investigating electroluminescence spectra of terbium embedded in these films as a luminescent probe. It is shown that changes in the relation of the intensities of bands, a decrease in their halfwidth and the background component, and simplification of the spectrum are observed in a short-wave region of the Tb radiation spectrum that corresponds to⁵D₃→⁷F_j transitions. The same modification of the radiation spectrum is characteristic of ZnS films whose crystalline structure is ordered in the course of thermal annealing at a temperature of 350°C. Based on the analysis of the data obtained it is inferred that irradiating the ZnS films with small radiation doses of 10⁴–10⁵ rad leads to the ordering of their crystalline structure due to the elimination of one of the types of structural defects. Institute of Physics of Semiconductors, National Academy of Sciences of Ukraine, 45, Nauka Ave., Kiev-28, 252650. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 3, pp. 338–341, May–June, 1997.     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

四（对-羟基苯基）卟啉氧合配合物的室温固相合成，表征及氧合能力

采用固相反应合成了四羟基苯基卟啉与与Fe^2＋,Co^2＋金属离子的配合物,在室温下,将其与分子O2作用,提纯后得到两种固态氧合配合物．通过元素分析、红外光谱（IR）、核磁共振氢谱（^1HNMR）、电导、热分析（TG／DTA）、紫外光谱（UV）等测试手段确定了氧合配合物的组成为[Co·THPP·O2]（NO3）2·2H2O、[Fe·THPP·O2]Cl2·2H2O]，可知1mol配合物吸收了1molO2,采用失重法测定了氧合配合物中的配位氧,确定1mol金属配合物吸收1molO2形成超氧配合物．     

空位在金刚石近(001)表面扩散的分子动力学模拟

用分子动力学方法模拟了空位在金刚石近(001)表面的扩散过程,研究了温度对空位扩散的影响.结果表明,当温度为1000K左右时,位于近表面第二层上的空位开始向表面运动;当温度在1400—2000K时,空位完全扩散到表面.这与实验结果和其他计算结果符合得很好.同时发现,温度为1400—1800K时,空位的扩散经历了两次迁移运动,其分别对应了均方位移图中的两个极大值.在不施加任何约束的条件下得到了空位的动态扩散路径,空位在金刚石近(001)表面的扩散势垒约为042eV.并探讨了一定温度下空位数目增多及其不同排列 关键词： 金刚石 空位 扩散 分子动力学     

PbWO4晶体空位型缺陷电子结构的研究

采用基于密度泛函理论的相对论性离散变分和嵌入团簇方法计算了PbWO4晶体中与氧空位和铅空位相关缺陷的态密度分布,并运用过渡态方法计算了其激发能.结果表明:PbWO4晶体中WO3+VO缺陷的O2p→W5d跃迁可引起350nm和420nm附近的吸收,并且发现VPb的存在可以使WO42基团的禁带宽度明显变小 关键词： PbWO4晶体 密度泛函 氧空位和铅空位 态密度分布